Thingiverse
Mini Shim
1
Download
0
Likes
0
Makes
I needed a small shim to stop my old windows from rattling, but this could be scaled up for anything.
MiniShim_v1 : The end comes to a sharp point. When printing at .2mm that small end is a bit thin and tends to break off, but if you're scaling this up that may be ok.
MiniShim_v2 : The end has been trimmed to 0.4mm height for better structure at the default size.
Width: 10mm
Length (Ramp): 32mm (Approx.)
Height (Ramp): 3.5mm (Approx.)
The length and height of the ramp are taken right up to where it starts to curve up for the tab.
MiniShim_v1 : The end comes to a sharp point. When printing at .2mm that small end is a bit thin and tends to break off, but if you're scaling this up that may be ok.
MiniShim_v2 : The end has been trimmed to 0.4mm height for better structure at the default size.
Width: 10mm
Length (Ramp): 32mm (Approx.)
Height (Ramp): 3.5mm (Approx.)
The length and height of the ramp are taken right up to where it starts to curve up for the tab.
matthewlinton pubblica anche su
35 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
