Mini skeeball

The mini skeeball game! Earn points by getting the ball through the holes on the target. The amount of points is specified beside the hole. No points are earned if the ball ends up in the big rectangular hole by the end of the ramp, on the ramp itself or completely outside the game. You use the rubber band shooter to shoot the balls along the ramp and then they'll fly into one of the point holes (hopefully) and end up in the ball holder at the rubber band shooter again. You can also try without the rubber band shooter and just use your hand and fingers like in the bigger version of the game but beware, it's pretty challenging. One of the parts (the target part) has two colors for more visible rings and amount of points. But don't worry if you dont have a multicolor printer for the target part you can just do a filament swap at layer 9, or just print it in one color if you think that will look nicest. Instructions for assembly are attached below and among the other photos above. Only thing you'll need is glue (i reccomend a glue that quickly and firmly sticks things together like superglue or similar) and a rubber band for the rubber band shooter. Supports and brim: Yes, i reccomend brim, but supports aren't nescesary for anything. Print times and filament usage: I printed everything in PLA (red, white and black), but other filaments will probably work too. In total evrything uses about 195 g of pla and takes about 8 h and 20 min to print on standard settings. I don't have acces to a resin printer so i have no idea if this is resin printable (or even what makes a thing (not) resin printable) but if you think/know it will work then go ahead.