mini stealthburner with induction probe

just wanted something cleaner and ended up making this, you cannot use the probe to home as it will get heat drift, so home using the switch and use the probe to make a mash, also use the mesh to help get your bed level by using them knobs, i ended up with this in my printer.cfg, but depending on what board your GPIO might be different, i am using the BTT SKR Pico, the probe i used i did cut up to get smaller but take your time, i soldered on the back of the PCB to get 24V and used the end stop pin, for ground and signal, on the other side, you will need to connect the other side to ground and signal to the probe pin for what ever you use for a indention sensor, make sure you connect things the correct way and also the correct probe pin as the signal is 24V and probably would let you the magic spoke it connect wrong, i would recommend using a millimeter to check things, the probe is called GX-H8B and is very cheap of aliexspress

the code used in in the description on the YouTube vi