Thingiverse
Mini table saw
von wd73_
1.3k
Downloads
945
Likes
0
Makes
This item is not intended to be a "print and ready" one, it is just for inspiration.
Feel free to download the various parts for this build for your own small table saw.
The table saw was built using:
- Various custom made 3d printed parts (duh..)
- some scrap wood
- some pieces of 15x15mm aluminium rod (for fence)
- an old Pfaff sewing machine motor (80W, 6000RPM)
- a AC motor speed controller
- 2 GT2 pulleys and a GT2 belt loop
- M8 threaded rod and aluminium rod for the blade height adjustment
- A 10mm rod as blade axle and 2 10mm bearings (pic says skate bearing = not correct!)
- 80mm cutting blade with 10mm hole
- some other misc. things and pieces..
It was a bit tricky to get the maximum cutting height out of this setup.
The blade only measures 8cm and the top is 18mm thick.
I thried to "thin out" the bearing blocks as much as possible and also
routed out some parts of the top lid where the axle/bearing blocks would hit
I managed to get 15mm maximum cuttin
Feel free to download the various parts for this build for your own small table saw.
The table saw was built using:
- Various custom made 3d printed parts (duh..)
- some scrap wood
- some pieces of 15x15mm aluminium rod (for fence)
- an old Pfaff sewing machine motor (80W, 6000RPM)
- a AC motor speed controller
- 2 GT2 pulleys and a GT2 belt loop
- M8 threaded rod and aluminium rod for the blade height adjustment
- A 10mm rod as blade axle and 2 10mm bearings (pic says skate bearing = not correct!)
- 80mm cutting blade with 10mm hole
- some other misc. things and pieces..
It was a bit tricky to get the maximum cutting height out of this setup.
The blade only measures 8cm and the top is 18mm thick.
I thried to "thin out" the bearing blocks as much as possible and also
routed out some parts of the top lid where the axle/bearing blocks would hit
I managed to get 15mm maximum cuttin
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
