Thingiverse
Mini Table Saw v1 - Direct Drive
von RayneMan
27
Downloads
36
Likes
0
Makes
Mini Hand Powered Table Saw - Direct Drive Version
"A fun and inconvenient way to cut a slice of bread in half that only takes 10 times longer than using a regular knife."
Check out the video to see it in action. https://youtu.be/jo2JSW73ru8
This is the Direct Drive version of my Mini Hand Powered Table Saw. It is operated by rotating the crank towards yourself to cause the blade to turn in the same direction.
I printed everything without supports except the Crank assembly and the Top. My Monoprice Select Mini printer was even able to print the Table Bottom without supports, though just barely. Some of the layers began curling under before it was able to bridge the gap and close the tops of the largest openings.
The half circle opening in the Crank is the hardest to clean out. I eventually added a drop of glue to keep it on the Crank shaft otherwise it would fall off after rigorous cranking.
When attempting to cut something, the Table should be held in place
"A fun and inconvenient way to cut a slice of bread in half that only takes 10 times longer than using a regular knife."
Check out the video to see it in action. https://youtu.be/jo2JSW73ru8
This is the Direct Drive version of my Mini Hand Powered Table Saw. It is operated by rotating the crank towards yourself to cause the blade to turn in the same direction.
I printed everything without supports except the Crank assembly and the Top. My Monoprice Select Mini printer was even able to print the Table Bottom without supports, though just barely. Some of the layers began curling under before it was able to bridge the gap and close the tops of the largest openings.
The half circle opening in the Crank is the hardest to clean out. I eventually added a drop of glue to keep it on the Crank shaft otherwise it would fall off after rigorous cranking.
When attempting to cut something, the Table should be held in place
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
