Slicer Discord
Mini Tesla Coil Base – Modèle 3D imprimable de Thingiverse Thingiverse
Mini Tesla Coil Base – Bild 1 Mini Tesla Coil Base – Bild 2 Mini Tesla Coil Base – Bild 3
Electronics

Mini Tesla Coil Base

75 Téléchargements
60 Likes
0 Makes
Voir le modèle
I found a bunch of Video's on YouTube to make small Tesla coils, some that play music etc. Using a standard empty roll of toilet paper roll, wrap a small wire around it about 276 turns the amount of turns don't matter a whole lot fill it up as much as you can.

The coil will slide around the center part, insert a wire in the perimeter holes, and connect the circuit.

*** The videos they show how this thing works seem to be phony, I did get one attempt to work actually, but kept smoking the transistor. a weak battery would probably be better for this project.. not sure but it did work well once ***

*** Dec 30 2016 Update ***
I've successfully got the coil to operate at very low voltages, not enough to light up a lamp, but enough to see 7V-p-p on a 5 Volt supply using a 2n3904 Transistor and using the base of the secondary as feedback to the transistor base, and a direct 5Volt across the primary coil via the collector-emiter on the transistor. I did have to get the frequency s
Catégorie
Electronics
Source
Thingiverse
Publié
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
grande impression
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 2/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Plateau min.
200 mm (Grand)
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection