Mini Wallet/ Card holder

This is a mini wallet/ cardholder I made for myself because I don't like bulky leather wallets. It holds up to four cards which you can push out through the finger cutout on top. The model is printed from PETG though PLA should work aswell while the strip is flexible TPU. It is glued into the inner cutout and will bend outwards, this is to press the cards down to prevent cards from falling out. Experiment and adjust length as needed, as I found the length and thus force required, varies depending on the cards which are used. For assembly simply glue the TPU strip into it's cutout, then on the half which has the TPU strip, put glue on the outside of the raised walls and slide the other half over so that the finger cutouts are aligned. I hope you have fun printing and encourage any feedback :D