Thingiverse
Mini Water Aircondition
door Norgaard87
33
Downloads
28
Likes
0
Makes
My take on a small table aircondition that uses water to cool down the air a few degreese.
everything can be printed mostly without support. Only the tunnel need a little support in the hole for the container. Only the fan needs to be attached with screws.
Use the template to cut out pieces of cloth that can suck up water.
Then use the guide to keep the right space bewteen top an bottom when sliding the cloth through the cracks.
now the top can slide into the tunnel and the bottom hangs down into the container.
The container can be filled with water for longer use.
it is important that the container is printed with thick walls and top and bottom to make it waterproof. If you dont get your first layer right it will leak water.
stay cool :)
everything can be printed mostly without support. Only the tunnel need a little support in the hole for the container. Only the fan needs to be attached with screws.
Use the template to cut out pieces of cloth that can suck up water.
Then use the guide to keep the right space bewteen top an bottom when sliding the cloth through the cracks.
now the top can slide into the tunnel and the bottom hangs down into the container.
The container can be filled with water for longer use.
it is important that the container is printed with thick walls and top and bottom to make it waterproof. If you dont get your first layer right it will leak water.
stay cool :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
