MakerWorld
Other Tools
Model downloaden
Mini water pump
917
Downloads
464
Likes
560
Makes
The tolerances of this mini water pump are very tight, so it may take a few adjustments to get it to work properly. I recommend ceiling the joint between the top half and the bottom half with hot glue, epoxies or some sort of waterproof glue. You only need 4 of the self tapping screws Linked below. What motor?Any motor that is 15 x 19.9 mm should work.Motor number, 29DCM1
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
