Thingiverse
Mini Wheel - Techno Phantom
door Schumo
13
Downloads
20
Likes
1
Makes
I recreated some classic (JDM-)wheels.
They're approximately 1:3 scale and have an diameter of around 13.5cm and a width of around 9cm.
They're not a perfect copy as I drew them just after some pictures from the internet.
Print them as you like, but I suggest to use "Archimedean chords" as the infill for the top layer, especially on wheels with silver faces.
The inner and outer lip should be printed with the flange down and print quite good without supports.
You'll also need:
M1.6x8mm bolts and nuts (as many as the lips have holes)
Maybe some glue for the center cap or if the centers are multi-piece
I'll do more designs soon, and I'm open for wheel suggestions.
They're approximately 1:3 scale and have an diameter of around 13.5cm and a width of around 9cm.
They're not a perfect copy as I drew them just after some pictures from the internet.
Print them as you like, but I suggest to use "Archimedean chords" as the infill for the top layer, especially on wheels with silver faces.
The inner and outer lip should be printed with the flange down and print quite good without supports.
You'll also need:
M1.6x8mm bolts and nuts (as many as the lips have holes)
Maybe some glue for the center cap or if the centers are multi-piece
I'll do more designs soon, and I'm open for wheel suggestions.
Schumo publiceert ook op
86 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!