Mini Whopper Plopper - 2 Inch

NOTICE: This model requires extra parts, and specific print settings. I have written an instructional guide on how to assemble the lure that matches with the photos in the Thing listing. Make sure you are printing with a calibrated printer that can handle the internal overhangs of the model. This model floats well with PLA Plus, I haven't tested with anything else. If there is enough of a demand, I can make an instructional video on assembly.

EDIT (07/04/2025): The model has been fixed! Print settings and the model have been updated, but it's the same assembly process as before.

EDIT (07/14/2025: I whacked both this and the new 3.5 inch plopper into the side of a bridge and shattered the tails. I've added a replacement tail model that should be able to slide over the wire and sort of snap into place. Just paint and seal before you snap it on. I've also updated the print settings for the tail.


Tired of spending $15 on a new lure every time your perfectly calculated cast gets thrown