Thingiverse
Mini-Z dummy
von disclaimer
0
Downloads
15
Likes
0
Makes
This is a highly adjustable Mini-Z autoscale dummy.
You can adjust height, length, width and camber.
It needs the following hardware:
5x M4 countersunk 16mm long bolts
4x M4 self-locking nuts
1x M4 regular nut
4x M2 12mm bolts (this is what acts as axle in the hub)
4x M2 8mm bolts (pivot point for the hub)
4x M2 regular nut
4x M2 self-locking nuts for the wheels or kyosho original ones
Arms will need the hole to be M4 tapped, ideally with a tap but you can get away just using a bolt if you use PLA or similar.
Use the desired hub depending on rim type you are going to use.
Provided holes to attach to any Kyosho autoscale case.
You can adjust height, length, width and camber.
It needs the following hardware:
5x M4 countersunk 16mm long bolts
4x M4 self-locking nuts
1x M4 regular nut
4x M2 12mm bolts (this is what acts as axle in the hub)
4x M2 8mm bolts (pivot point for the hub)
4x M2 regular nut
4x M2 self-locking nuts for the wheels or kyosho original ones
Arms will need the hole to be M4 tapped, ideally with a tap but you can get away just using a bolt if you use PLA or similar.
Use the desired hub depending on rim type you are going to use.
Provided holes to attach to any Kyosho autoscale case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
