Thingiverse
Miniature Toothpick Holder
door PottsyPrints
0
Downloads
1
Likes
0
Makes
Was just looking for something to hold up my printed miniature parts. It's a known trick to squeeze in toothpick ends into the body holes or between the plastic sides and I wanted something to hold the other end without spending £20 on amazon.
The holes are 3mm wide, your average toothpick is 2mm so it leaves room to just slide down.
Each hole is 30mm deep, your average toothpick (For those snack plates and picking teeth) is 60mm long...Those extra long toothpicks you can get for like Skewers and things I don't think will stay in the holes, so not for those!
The holes are 3mm wide, your average toothpick is 2mm so it leaves room to just slide down.
Each hole is 30mm deep, your average toothpick (For those snack plates and picking teeth) is 60mm long...Those extra long toothpicks you can get for like Skewers and things I don't think will stay in the holes, so not for those!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
