Thingiverse
MiniFuse knob light blocker
por XienixPS
0
Descargas
0
Likes
0
Makes
The blinking light was a bit distracting. There is no way to turn it off :(
I could have taken it apart and desoldered the light. but something about a warrenty. So I made this knob cover to reduce the light quite a bit.
You can still see it blink, but it's not really noticable, unless you're actively looking at it (see before/after picture).
The design is still the same, just a bit more chunky in order to block most of the light.
The overlap between people with this audio-interface, a 3D-printer AND poeple who are bothered by the blinking led, is probably pretty small...but if it is you, then here you go :)
I designed it for the MiniFuse 1, but the knobs on the MiniFuse 2 look similar sooo it is probably compatible with that one as well.
I could have taken it apart and desoldered the light. but something about a warrenty. So I made this knob cover to reduce the light quite a bit.
You can still see it blink, but it's not really noticable, unless you're actively looking at it (see before/after picture).
The design is still the same, just a bit more chunky in order to block most of the light.
The overlap between people with this audio-interface, a 3D-printer AND poeple who are bothered by the blinking led, is probably pretty small...but if it is you, then here you go :)
I designed it for the MiniFuse 1, but the knobs on the MiniFuse 2 look similar sooo it is probably compatible with that one as well.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
