Thingiverse
Minigun Keychain
door Freckles667
1
Downloads
4
Likes
0
Makes
As most of my things are, I did them because I was bored, so here you go, its very basic, and obviously I haven't painted it, but you easily can and make it look much better.
If you print it in the orientation that is in the thumbnail then you don't/shouldn't need supports.
BTW I might change a few things in the future, but IDK.
If you print it in the orientation that is in the thumbnail then you don't/shouldn't need supports.
BTW I might change a few things in the future, but IDK.
Freckles667 publiceert ook op
18 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
