MakerWorld
Electronics
Go to Model
Minimal 64x4 Home Computer Case
1
Downloads
0
Likes
0
Makes
I designed a computer case for my friend’s Minimal 64x4 Home Computer project.It barely fits on his A1 printer bed :D.The power button’s push switch size may vary depending on which micro switch you install on the board. (If the size needs to be adjusted later, I’m happy to modify it for anyone who needs.)Eight 4x2mm magnets are required to secure the lid.A 150x200mm, 2mm thick acrylic sheet should be glued into the lid’s cutout to keep dust out while still allowing the panel to be visible. I also glued the magnets in place to ensure they stay firmly attached.You can read more about the project here:https://github.com/slu4coder/Minimal-64x4-Home-Computer
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!