Minimal Toothpaste Squeezer V1

Made to be simple and minimal, this toothpaste squeezer actually works It has a small wedge that helps push toothpaste out without making the tube hard to put in. The side that lays flat on the build plate is the side opposite where you put the tube in. You can use the flat side too, it just works a little better from the opposite side. The height is set to a sweet spot. Any lower and it’s harder to squeeze (from my tests). Print info Prints in under 15 minutes on a Bambu Lab A1 mini No supports needed Tested with PLA, should work with most filaments Fits most standard toothpaste tubes I’m taking feedback, so if you print it or have ideas, drop a comment.