minimalist bottle balancer (parametric)

not all bottles are the same, but this one should work for most. This design was inspired by Chris, and so it shall be known as the Chris balancer! If you have a particularly short bottle, you may need to keep the neck from going in all the way. If you find that it is not stable and want to adjust, for bottles wanting to tip left (as seen in my pic) you would want to make it shorter. The bottle in the picture is a taller typical riesling style bottle but a different (shorter) style bottle would benefit from dropping maybe as much as a cm. Alternatively you can just do like I already said above and not set the neck all the way in. I printed without supports and a higher infill like 40-50 i think, you dont want that main part to flex else it will alter the center of mass.