Minimalist Kitchen Collection

Minimalist Kitchen Collection I wanted to organize my kitchen drawers without tasking too much time and or filament. Many models out there for this have ticker walls and bottom and use more filament. I have tuned these boxes to be as sturdy as needed while using the least time and filament possible. I did adjust the print profile as well. I am using a .4mm nozzle and a .28 layer height. The boxes might seem a little flimsy by themselves but once all installed in the drawer they are plenty sturdy. This system is based on the Gridfinity system developed and created by Zach Freedman. I am including these models: (Width x Length x Height units) (1x1x9) Single box (1X4x9) 3 slots full length (1x4x9) Small Spoon (1x6x9) 3 slots no finger holes (1x6x9) Knife LT Side End (1x6x9) Knife (2x2x1) Filler panel (2x3x1) Filler (2x4x1) Filler panel (2x5x1) Filler panel (2x5x9) Fork big and small(2x5x10) Finger slope (3x3x1) Filler panel (3x5x9) apple cutter no cut out (3x5x9) Forks Spoons (4x6x9) slot