Thingiverse

minimalist rocket

par bt10anastasios

0 Téléchargements

0 Likes

0 Makes

a minimalist rocket that can be used as a piece in a board game, a child's toy or a decoration and anything else

I printed this with pla and on standard scale it is 6cm tall (about 2 inches)

it prints in two pieces and takes about 1 hr to print depending on your speed

because its made so it doesn't need glue to connect it might be tough to connect if your printer isn't dialed in or you print in a smaller scale in which case just take the filament cutters that usually come with your printer or a knife and just trim the top; that shoud do the trick

i suggest using the adaptive layers setting but it will look just fine if you print it with pla matte

if you have any question or any suggestions feel free to comment