Thingiverse

Minion Spinner

von jweber01

10 Downloads

8 Likes

0 Makes

I used a 5/16" hex nut and a 608 long board bearing. They are a tight fit and I had to hammer them in. I haven't had any problems with the nuts coming out. The bearing is greasy and will slide out if you use it a lot or get rough. You might clean the grease off of the outside to help it stay longer, but I just used the Simple Bearing Cap from Very Customizable Fidget Spinner to make it easier to hold and to keep your fingers grease free.
I used a Brown Sharpie to color the bands for the goggles.

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat