MiniPET 4032 Case

This is an original COREi64 design for the MiniPET computer. This design is for the very first release of this computer. The guy that created the MiniPET seems to enjoy continually updating it, thus, don't expect later versions of his design to work with my case.

Fasteners I used for this case are:

5 - M2 brass heatsets
5 - M2, 10mm black oxide screws

I printed this using PLA. It was printed with the base on the build plane, and the top with the void facing the build plane (top up). Support will be needed for printing the top. Contact the Badgeman for the correct MiniPET4032 badge. I printed this case at 80 percent infill because I wanted it to have some heft to it so it wouldn't skate around on my desk, but you could get away with less infill if you wanted.