Thingiverse
Mintion BeagleCam Pod Adapter
von Yaume
51
Downloads
37
Likes
1
Makes
FR
Adaptateur pour mettre une caméra Mintion BeaglePrint sur un pied avec une vis standard (kodak).
Il faut mettre une pause pendant l'impression de façon à insérer un écrou M7.
Les supports ne sont pas obligatoires. Si vous en mettez, spécifiez uniquement depuis le plateau et vérifié que le Slicer n'en génère pas au niveau de l'emplacement de l'écrou.
EN (Google traduction, sorry)
Adapter to put a Mintion BeaglePrint camera on a stand with a standard screw (kodak).
Pause during printing to insert an M7 nut.
Media are not mandatory. If you put some, specify only from the tray and check that the Slicer does not generate any at the location of the nut.
Adaptateur pour mettre une caméra Mintion BeaglePrint sur un pied avec une vis standard (kodak).
Il faut mettre une pause pendant l'impression de façon à insérer un écrou M7.
Les supports ne sont pas obligatoires. Si vous en mettez, spécifiez uniquement depuis le plateau et vérifié que le Slicer n'en génère pas au niveau de l'emplacement de l'écrou.
EN (Google traduction, sorry)
Adapter to put a Mintion BeaglePrint camera on a stand with a standard screw (kodak).
Pause during printing to insert an M7 nut.
Media are not mandatory. If you put some, specify only from the tray and check that the Slicer does not generate any at the location of the nut.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!