Thingiverse
MipBip paragliding variometer holder
von gsimon_fr
0
Downloads
1
Likes
0
Makes
Hello,
Here I propose my holder for the MipBip from Mipfly
Can be assembled on risers of 2.2mm thickness, maximum 30mm width.
I recommend to print in PETG
BOM:
- x4 M3x10 socket head screws
- x4 M3 nuts
(Normally, if you have a Prusa, you have this hardware in stock :-) )
Print it without support, as it is in the STL.
Here I propose my holder for the MipBip from Mipfly
Can be assembled on risers of 2.2mm thickness, maximum 30mm width.
I recommend to print in PETG
BOM:
- x4 M3x10 socket head screws
- x4 M3 nuts
(Normally, if you have a Prusa, you have this hardware in stock :-) )
Print it without support, as it is in the STL.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!