Thingiverse
Mirror Protection
von marinorl
0
Downloads
0
Likes
0
Makes
I have been asked to design and 3D print some kind protection to my wife's pocket or better, bag collapsible mirror. Mirror is of better quality and she was affraid to damage it, when she travel. Mirror have two sides: one normal and one with magnifying surface. As you can se, this mirror does have a stand or foot.
As she likes this design and you may have a need for such one, I decided to put it here.
Mirror's dimension:
- outer diameter is 126mm
- width: 12,5mm, when foot collapsed: 20mm
On the rear side was, of course my wife's name, but I replace it with single word: Mirror.
As she likes this design and you may have a need for such one, I decided to put it here.
Mirror's dimension:
- outer diameter is 126mm
- width: 12,5mm, when foot collapsed: 20mm
On the rear side was, of course my wife's name, but I replace it with single word: Mirror.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!