Thingiverse
Mistral-E Noctua Remix
door jonasgddfr
149
Downloads
115
Likes
2
Makes
A remix of the Mistral-E cooling duct by Leo_N because I was irritated by the loud 4010 standard Creality Blower.
This one uses a 40x40x10 or 40x40x20 Noctua fan, or some other 24V fan if your don't want the hassle with the electronics. Don't solder a buck converter in between the wire, as they are not compatible with the PWM your mainboard sends out.
I redrew the entire part in Fusion 360 in order to get good dimensional accuracy and clearance for the bolts of the X-axis tensioner.
Best to print in a more heat resistant material such as PETG or ABS and to equip your hotend with a silicone cover.
Use the longer two M2 bolts from the original blower to mount it to the fan casing.
This one uses a 40x40x10 or 40x40x20 Noctua fan, or some other 24V fan if your don't want the hassle with the electronics. Don't solder a buck converter in between the wire, as they are not compatible with the PWM your mainboard sends out.
I redrew the entire part in Fusion 360 in order to get good dimensional accuracy and clearance for the bolts of the X-axis tensioner.
Best to print in a more heat resistant material such as PETG or ABS and to equip your hotend with a silicone cover.
Use the longer two M2 bolts from the original blower to mount it to the fan casing.
jonasgddfr publiceert ook op
14 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
