MakerWorld
Machine Tools
Go to Model
Miter Saw Zero Clearance Insert
95
Downloads
54
Likes
46
Makes
This is a replacement for the throat inserts on the DW717 Dewalt 10" sliding compound miter saw. Simply swap this solid insert in for the two half-inserts that come in the box. Make a slow cut through this plate, and then clean up the edge with a razor. I recommend printing in a bright color for safety and visibility. Notes - v1.0: It prints in two halves with an interlocking joint, but I also recommend adding CA glue to eliminate the possibility of vibrationBoth halves each have 3 of the 6 screw holes, again to minimize vibrationThere is an 8mm 100% infill spine running through the center to provide extra support after slot has been cut
Cannonhappy also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!