MakerWorld
Cosplay Weapons
Zum Modell
Mjolnir - Thor Hammer
5.1k
Downloads
1.8k
Likes
2.8k
Makes
This is a full size Mjolnir. Yes, full size. It's big. It takes about 600g of filament and around 19 hours to print, even on a P1S. It prints really, really well. I've simplified the model so it's basically a full hammer, a top and bottom handle (and a pommel) and then then some easily glued in plates for the hammer head. It's a no-brainer to assemble but it looks amazing. How have I got a full size Thors Hammer onto a single plate? Lots and lots of model editing and a lot of work getting supports set up properly. I've also spent a long time arranging the model so it fits on the plate and prints well. This hammer is big. It feels heavy when you hold it and it really looks something. I've made 4 of them and given 2 as gifts. I've made one of these on the P1S and the print quality is just incredible. Please check out the new V3 print profile. It contains changes that means the print uses less filament and the hammer is easier to assemble. This remix contains s
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!