Thingiverse
Mk2 speedloader for Dan Wesson (push-button)
door Saniainen
95
Downloads
84
Likes
0
Makes
[edit 20.2.26] Some improvements based on user feedback. New cap and shaft design features tighter swirl fit and better geometry, included bigger button and reduced file size.
New version of push-button design. It features countless small improvements, but most important part, there's no longer a need to unscrew the cap to reset the mechanism.
Tested with only with airsoft shells. They are modeled after .357 magnum, so it should work with it and .38 Special. But no guarantees as I can't test it.
"wider-" and "widestLock" pushes cartridges further apart,
"retainerTighterCap" is thicker on cap side, use it if your cap is loose.
You will need:
1x M3x12mm(or longer) bolt
That's it!
New version of push-button design. It features countless small improvements, but most important part, there's no longer a need to unscrew the cap to reset the mechanism.
Tested with only with airsoft shells. They are modeled after .357 magnum, so it should work with it and .38 Special. But no guarantees as I can't test it.
"wider-" and "widestLock" pushes cartridges further apart,
"retainerTighterCap" is thicker on cap side, use it if your cap is loose.
You will need:
1x M3x12mm(or longer) bolt
That's it!
Saniainen publiceert ook op
56 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
