MK3 Based Modded Extruder Set

Finally it is done, just like the previous mk2's extruder set where I modified them to be compatible with other auto bed leveling probe out there instead of just 8mm size. This one however, also been modified to be interchangeable between the MMU and Direct Drive.

I had to print the parts several times due to the fact that nut's slot sometimes too small for the nuts to go in. The original design was to accommodate square nut, I don't have any square nuts to be used with the parts.

I've found this one https://www.thingiverse.com/thing:2740929 and https://www.thingiverse.com/thing:2736405. There are reports from the forum saying it eliminates the filament jam especially for prusa's original mmu. I highly suggest to use that rather than using mine