Mlock pressure switch mount

Pressure switch mounts for mlock rail. Compatible with most switches that are less than 1/2x3 inches. Use the flat version for wider switches.

Must print with supports due to the small tabs on the bottom that help secure it to the mlock system. I also recommend a higher infill percentage to make it strong.

1. Place small zip ties through the mount first. This is not required to do first, but it makes step 3 a lot easier.
2. Secure the mount to your weapon with Mlock compatible nuts and screws. I recommend using a bit of Loctite to prevent the screws from coming loose because you won't have aceess to the screws once the switch is mounted.
3. Use small zip ties and/or double-sided tape to secure the switch to the mount. If the zip ties cross over the middle of your switch, don't tighten them so tight that they activate the switch unintentionally.

Optional: You can use RTV silicone for a more secure mount. Please note that RTV silicone will most likely be permanent and you will