myminifactory
3D Print of Flakpanzer IV AA Kugelblitz - Germany Eastern Western Front Normandy Stalingrad Berlin Bulge WWII
Download Modelby Unbekannt
0
Downloads
1
Likes
0
Makes
0
Kommentare
Hello Adrien,
Thank you for your reply and for updating the turret ring.
As shown in the attached photos, the issue I encountered is that the protruding length on the underside of the ball-shaped turret is significantly longer than the depth of the recessed groove on the lower hull. Because of this mismatch, the turret cannot sit flush and ends up floating above the hull instead of fitting properly.
Unfortunately, I do not own a 3D printer myself and had this model printed through a third-par
Thank you for your reply and for updating the turret ring.
As shown in the attached photos, the issue I encountered is that the protruding length on the underside of the ball-shaped turret is significantly longer than the depth of the recessed groove on the lower hull. Because of this mismatch, the turret cannot sit flush and ends up floating above the hull instead of fitting properly.
Unfortunately, I do not own a 3D printer myself and had this model printed through a third-par