Thingiverse
Mobile phone hook holder
von danutdruta
0
Downloads
0
Likes
2
Makes
Depending on your printing speed you may check adhesion layer setup on Cura.
Having some issues on first layer with 150mm/s, but with 100mm/s works pretty smooth.
Also I've tried with 0.6 nozzle and it looks pretty good.
Having some issues on first layer with 150mm/s, but with 100mm/s works pretty smooth.
Also I've tried with 0.6 nozzle and it looks pretty good.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
