Thingiverse
mobile stand
by Simakrima
5
Downloads
9
Likes
0
Makes
Another student designed a mobile stand with a hole for the charging cable. The original SketchUp-file is in cm, but it was meant in mm, so you have to scale the stand for printing down to 10%.
We printed it with a wood-filament made of cocos-nuts. (Nozzle: 0.8mm, layer heights: 0.3mm all over the model).
After that, we saw, that there are some holes in the print, so i have worked on it again and i think, i could manage it, so that the obj-file now should make a good print without small holes, but we don't guarantee it.
We printed it with a wood-filament made of cocos-nuts. (Nozzle: 0.8mm, layer heights: 0.3mm all over the model).
After that, we saw, that there are some holes in the print, so i have worked on it again and i think, i could manage it, so that the obj-file now should make a good print without small holes, but we don't guarantee it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
