Thingiverse
MobileVise (remix)
by psfales
6
Downloads
7
Likes
0
Makes
Very clever design, and kudos for providing the .scad file. Using the .scad file, I was able to tweak it just a bit:
- Changed the length from 100 to 110 mm, so that I can use an M6x100 bolt.
- Moved the groove just a bit farther from the edge so that the point is not so sharp. On my slicer, the sharp point resulted in no material extruded in the first couple of layers.
- Changed the length from 100 to 110 mm, so that I can use an M6x100 bolt.
- Moved the groove just a bit farther from the edge so that the point is not so sharp. On my slicer, the sharp point resulted in no material extruded in the first couple of layers.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!