Thingiverse
Mobius puzzle
por GregLen
0
Descargas
1
Likes
0
Makes
This Mobius ring has a square cross section.
The two parts fit together in sixteen different ways; fifteen of them are wrong!
There is a 0.4mm clearance between the parts.
Tricky to print as there is no flat surface for the hot bed.
Prusa Slicer added support material, but the finish is not very good on my KLP1 peinter
The two parts fit together in sixteen different ways; fifteen of them are wrong!
There is a 0.4mm clearance between the parts.
Tricky to print as there is no flat surface for the hot bed.
Prusa Slicer added support material, but the finish is not very good on my KLP1 peinter
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!