Moblite 6 / 7 Canopy Camera Mount

I designed this to work with my moblite 6 to reduce the shaky stock mount. This weighs less than 1 gram and doubles as a nice roll cage for the quad.

I believe the moblite 6, 7, and mobula 65/75 all have the same bolt-up so this may work for all 4.

IMPORTANT: This is press fit on the camera, so its tight. Take a knife and scratch all 4 internal corners of this mount until the camera presses in without too much force, but be careful and not go too far as it wont be snug.

IMPORTANT: Print 2-3 at a time so you dont put too much heat into 1

I used 1.2x6mm screws just to be safe $7 for a massive set on amazon. The stock screws did work but barely.

I print using a 0.4mm ruby and recommend the following settings if using abs:

0.2mm layer height
support at 10%
100% infill
45-55mm/s print speed.