Moblite 6 Race Canopy

This is a solid 15 degree camera mount. The camera presses into the mount, so its a tight fit. I had to take a knife to lightly clean up the camera hole and then the camera just presses in.

The L shaped peice goes on the bottom side of the mount after the main mount is screwed onto the moblite with camera in place. Take a 1-1.2mm x 4mm or 5mm screw and use the L shaped peice to secure the camera mount to eliminate vibrations. That screw goes in from the top.

I belive the moblite uses 1.2mm screws. But i had better luck with 1mm screws. I recommend an assorted screw kit from amazon for $7, mines had 750 screws ranging 1mm-1.7mm diameter, 3mm-8mm long

For best results i print with a 0.4mm nozzle at a 0.2mm layer height. The electronics cover is a remixed.

Printer must be dialed in for these small parts. Print 2 of everything at a time to reduce heat and warping.

Enjoy