Moblite 6 Race Canopy

I designed this for the moblite 6 with the help of RCgroups support.

The weight ranges from 0.5g to 1.2g

For a lighter print, print a 0.2mm layer height on a 0.4mm nozzle. The infill on the first 0.8mm determine the weight. For example: if the first 0.8mm you use 15% infill with no top layer nor bottom layer. then you will end up with 0.5g. Trade off between infill, strength, and protection. The main settings to play with are perimter/shell and infill with no top or solid layer for the first 0.8mm as thats the height of the cover.

There is a support that goes on the bottom side and screws in from the side. This support holds the camera down against the moblite frame.

The original front screw hole can be used to adjust the camera angle. If you leave it out, then its around 10 degrees. From there, adding it and cranking down makes the camera angle go up.

Use a custom placed support under the camera lens shroud.

There's a big set of screws on amazon for $7 that