Thingiverse
Mobula7 stock canopy
von R3OVER
78
Downloads
47
Likes
1
Makes
This is a stock replacement canopy/cam mount I designed and printed. Seams to work well. I will probably be doing another version (stronger/lighter) soon.
The test prints were all done in PLA, but the final one I had printed in Onix (carbon fiber embedded nylon) for strength. I would recommend printing in ABS, nylon, or even TPU if your feeling adventurous.
Use your stock screws and a little strip of sticky back foam when inserting the camera to help hold the camera in place.
The test prints were all done in PLA, but the final one I had printed in Onix (carbon fiber embedded nylon) for strength. I would recommend printing in ABS, nylon, or even TPU if your feeling adventurous.
Use your stock screws and a little strip of sticky back foam when inserting the camera to help hold the camera in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!