Mobula7 top battery mount

Wanted to try moving batteries above props to improve vertical CG... it's a tough one to print but it's as light or lighter than stock. Most walls are .8mm. I have not printed the flanged version. My intent is .2mm nozzle, have not tired anything bigger. Supports are required. Use a brim on the non flanged version. Added the flange while non flanged was printing, don't think it's necessary. Standoffs can be cut down or other frames with short stand offs can be used to lower canopy. I'd recommend TPU, don't think anything will take the abuse. I'd recommend some type of washers on the screws to distribute load, especially the cam mount pair.

If you try it, please let me know what you think....