Thingiverse
Modded Mattress
von Speedhump
0
Downloads
2
Likes
0
Makes
Wanted rockets for this, so my Aussies would have something to shoot at the Bad guys.
Discovered the holes were not all the way through, and some tubes were out of alignment.(Typical British rocket launcher construction if you ask me...)
So I redid the launcher tubes, and made up a rocket head to put in the end. All measurements were eyeballed to match the original design, and it printed well. (Fits the existing trailer etc well.
Now I need to clean the strings off the 30 or so rockets....
Discovered the holes were not all the way through, and some tubes were out of alignment.(Typical British rocket launcher construction if you ask me...)
So I redid the launcher tubes, and made up a rocket head to put in the end. All measurements were eyeballed to match the original design, and it printed well. (Fits the existing trailer etc well.
Now I need to clean the strings off the 30 or so rockets....
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!