Thingiverse
Model Building Risers
by Rastl
3
Downloads
4
Likes
2
Makes
This is a set of risers to help with assembling models. The risers go from 1mm to 5mm and can be used in any combination to acquire the necessary height to hold a model off the table while other pieces are glued in place.
1mm and 2mm do not have sockets or pegs since they're too thin for that. 3mm, 4mm, and 5mm have stackers (sockets and top pegs) and toppers (sockets).
They don't snap-fit and can be angled around to hold the model in whatever configuration is needed.
Consider these the cinder blocks of model building. :)
1mm and 2mm do not have sockets or pegs since they're too thin for that. 3mm, 4mm, and 5mm have stackers (sockets and top pegs) and toppers (sockets).
They don't snap-fit and can be angled around to hold the model in whatever configuration is needed.
Consider these the cinder blocks of model building. :)
Rastl also publishes on
5 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!