Thingiverse
Model Defibrillator
0
Downloads
3
Likes
0
Makes
A toy defibrillator.
You will need:
x2 5mm diameter springs, about 30mm long. I used a part from (https://www.amazon.com/dp/B0BWHZFTZK?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1)
x1 10mm wide LED. I used (https://www.amazon.com/dp/B01AU6UG70?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) and cut out the rubber sleeve
Print body bottom side down. Print paddles hole side down. Glue the springs in to the designated holes on two defibrillator pads, and one defibrillator base. The led should stick out slightly from the top. The LED can be programmed to flash by a separate logic controller.
You will need:
x2 5mm diameter springs, about 30mm long. I used a part from (https://www.amazon.com/dp/B0BWHZFTZK?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1)
x1 10mm wide LED. I used (https://www.amazon.com/dp/B01AU6UG70?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) and cut out the rubber sleeve
Print body bottom side down. Print paddles hole side down. Glue the springs in to the designated holes on two defibrillator pads, and one defibrillator base. The led should stick out slightly from the top. The LED can be programmed to flash by a separate logic controller.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!