Thingiverse
Model Rocket Launch Pad
door marmotjr
321
Downloads
200
Likes
1
Makes
As one other member mentioned, there is a surprisingly few number of model rocket launch pads on here. This was made for my nephews Christmas gift, the launch controller will be soon to follow.
The pad is modular, so it has a wide base, but comes apart for easy storage and transport.
Using a 8" (200mm) cubed print volume, just be aware both the legs and core take up most of the usable print bed area.
Center hole is a 1/8" for standard size rods, I'll look into releasing the 3/16" size for the maxi rods if anybody asks. The hole I printed was a hair tight, but when I went to drill it out with 1/8" bit, it was bigger than the bit. Used a 9/64" bit and shaved off just a bit, but the rod fit nicely then.
You MUST use a metal blast plate!!! Most plastics used in FFF printing can't handle direct exposure to motor exhaust.
1/2026 Update: Well, somebody asked, so I have included a 3/16" maxi version. Welcoming feedback on fit, as I have not printed one.
The pad is modular, so it has a wide base, but comes apart for easy storage and transport.
Using a 8" (200mm) cubed print volume, just be aware both the legs and core take up most of the usable print bed area.
Center hole is a 1/8" for standard size rods, I'll look into releasing the 3/16" size for the maxi rods if anybody asks. The hole I printed was a hair tight, but when I went to drill it out with 1/8" bit, it was bigger than the bit. Used a 9/64" bit and shaved off just a bit, but the rod fit nicely then.
You MUST use a metal blast plate!!! Most plastics used in FFF printing can't handle direct exposure to motor exhaust.
1/2026 Update: Well, somebody asked, so I have included a 3/16" maxi version. Welcoming feedback on fit, as I have not printed one.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
