Model rocket launch rod holder

Hardware needed:
3 M5 nuts (one to be printed into the inside piece, 2 for the M5 bolts)
2 M5 bolts (to attach base to the platform)
1 1/4 inch bolt, 1 inch long (to connect the inside and outside parts)
1 small knob (or wingnut and washer) for the 1/4 bolt
1 M5 x 10mm Male Thread Thumb Screw (optional)

This will work with both 1/8 and 3/16 launch rods and allows for a tilt up to 15 degrees.

Insert the rod into the hole in the top of the holder and use the thumb screw to hold it in place. If you don't want to use the printed thumb screw, you can use a metal M5 x 10mm Male Thread Thumb Screw which will likely give a better grip.

When printing the launch rod holder part, orient it as shown in the images and set the print to pause before it prints the layer that covers over the area where the M5 nut goes. Drop the nut into the hole, then let the print proceed to seal the nut into the print. When assembling be sure to orient the parts so the thumb screw is on the other si