Thingiverse
Model Rocket Tail Cone
por Cybus
121
Descargas
73
Likes
1
Makes
A more realistic rocket engine tail cone than the ones included in Estes kits.
It's scaled to fit an Estes BT-60, which has an inside diameter of 1.595 inches. It should slide in easily, but that may depend on your printer.
Make sure the end of the motor tube is fairly close to the bottom of the nozzle so it isn't exposed to too much heat.
It's scaled to fit an Estes BT-60, which has an inside diameter of 1.595 inches. It should slide in easily, but that may depend on your printer.
Make sure the end of the motor tube is fairly close to the bottom of the nozzle so it isn't exposed to too much heat.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
