MakerWorld
Office
Go to Model
Modern drawer
13
Downloads
10
Likes
5
Makes
The drawer is compatible with the monitor riser available on my profile. The drawer slide is mounted with four screws, preferably flush with the edge. Two clips are included to prevent the drawer from sliding out completely. The clips are attached by pressing them into the holes in the back of the drawer (as shown in the attached visualization). Printed with PLA and a layer height of 0.24, but you can easily adjust the settings for even better quality.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
