Modern Interlocking Squared Containers

WORK IN PROGRESS :)

This is my first attempt at modeling a container. I wanted to make something big enough to fit most of the bulkier stuff I see laying here and there on my desk, while still being stylish enough not to hear too many complains from my otherwise loving wife.

Most of the inspiration is from the [Modular Drawers 2.0](https://www.thingiverse.com/thing:2539830) by O3D. Compared to this one, I simplified the rails that are now just 2 per side. All rails are identical so modules will connect by printing a bunch of small pegs to slide into the rails where needed. This reduces overal printing time a little bit while also allowing all faces to be mostly flat.

Back is left open to save some filament while front is designed to nicely stop the drawer from slipping inside the structure.

I must confess that any model that is around 13x13x20cm is not going to be fast nor cheap to print so I am still looking for ways to lighten up the structure. I will defintely post my ac