modified Case for Open Source Theremin

This is a modification of the design of Gaudi (http://www.thingiverse.com/gaudi). I bought the kit without the adjustable resistors, so i modified the case to remove the holes.
Also widened the holes of the calibration resistors a little bit so they where easier to reach.
And i removed the rings around the holes, so i could print it laying flat, but that turned out ugly.
The only way to get a nice case is to print it standing up. Use i brim for extra stickyness (i used 5mm) and rotate the objext 115 degrees so the bottom is flat on the printbed.

If you print the bottom from http://www.thingiverse.com/thing:978043 and need to threat the screw for the tripod mount, i found it easy to heat up the screw and then turn it into the bottom plate and let it cool down.

The Theremin shield does not fit into the case with the banana connectors mounted. So i attached the 3mm bolts to the shield first and then when the shield was in the case used extra nuts to fasten the banana connectors o